Copyright© 2005-2009, Integrated Instruments & Systems Private Limited. All rights reserved. Site Designed and Hosted by Nikitha Web Services
Integrated UPS with Built - In Line Conditioner
- Designed indigenously with advanced technology.
- Perfectly suitable for hostile Indian Power Conditions.
- World standards to match imported brands of UPS systems.
- UPS + Line Conditioner + Remote Interface* -- ideal for any Computer environment.
- Protects your PCs, LAN from the polluted Mains Power due to Prolonged Low Voltages, Over Voltages, Power Failures.
- Unique features like No Load Cut Off, Stepped Sine Wave output, Regulated Battery Charger.
- Static transfer assures ultra fast change over time.
- Built-in Sealed Maintenance Free Batteries (SMF).
- Back-up time from 15 minutes.
- Directly switches ON without mains power.
- Wide levels of voltage correction to keep your computers working through much deeper and longer brownouts and over voltage conditions, without draining battery power.
- Remote interface for unattended operation. (*Optional)
Technical Specifications
MAINS OPERATION
* 100% Solid State AVR Relay based Static Line Conditioner.
* Ultra Fast Correction Time Less than 10 m. seconds
* Wide Input Working Voltage Range 160 to 270 volts.
* Auto Under & Over Voltage Protection and Auto-Restart
* Full time Power Surge and Spike Suppression Protects from Surges, Spikes and Lightning.
* Auto Noise Filtering Protects sensitive loads from Electrical Noise.
* CVCC Battery Charger Fast Charging.
BACKUP OPERATION
* Static Change Over Relay based Transfer Switch.
* Effective PWM and Efficient MOSFET Design Provides maximum battery run time.
* Stepped Sine Wave Output
* Auto Power Save Shuts off Automatically, if all loads are Off, Saving Battery Power.
* Long Back Up Time 15 to 60 minutes (Optional).
* Automatic Over Load Protection
* Warning System Beeping Sound indicating the Mains Failure and Battery Low.
* Remote Interface (Optional) RS 232 Communication Port.
* Extremely Compact
* High MTBF Rugged Single Board design, ensures high mean time before failure.
* Easy to Install and Operate
POWER RATING
|
500 VA
|
Voltage
|
160 – 270 V AC
|
Frequency
|
47 – 53 Hz
|
Phase
|
Single Phase
|
Battery
|
12V, 7AH, SMF (Internal)
|
OUTPUT
|
|
Voltage on Mains
|
220V + 20 V AC (Nominal)
|
Voltage on Battery
|
220V + 20 V AC (RMS)
|
Regulation
|
+ 2% for 10 to 90% load change.
|
Frequency
|
50 Hz + 1%
|
Wave form
|
PWM Stepped Sine Wave.
|
AVR Correction Time
|
Less than 10 m. seconds for given Input Range.
|
TRANSFER
|
|
Time
|
Less than 3 m. seconds.
|
Mains to Inverter
|
Low voltage at 160 V and High voltage at 270 V.
|
Inverter to Mains
|
Low voltage at 165 V and High voltage at 265 V.
|
Recharge Time
|
4 hours to 6 hours.
|
Load
|
1 PC + 1 Printer (not Laser Printer).
|
Back Up
|
15 Minutes.
|
PROTECTIONS
|
|
Input
|
Fuse.
|
Output Over Load
|
Electronic Protection in Backup Mode, if Load exceeds 110% of Rated Capacity.
|
Output
|
Fuse
|
Spike
|
Surge and Spike Suppression.
|
INDICATIONS (LED’s)
|
|
Mains OK (Green)
|
When Mains Voltage is within Input Range.
|
Back Up (Yellow)
|
Blinks every 10 seconds in Inverter Mode and every 1 second for Battery Low alarm.
|
Power Save (Yellow)
|
UPS trips after 30 seconds, if Load is <5% of Rated Capacity. Manual Reset.
|
Over Load (Red)
|
UPS trips due to excess Load (more than 110% of rated capacity) or due to Output Short.
|
Battery Low Trip (Red)
|
UPS shuts down due to Low Battery Voltage.
|
ALARM
|
|
Mains Failure
|
Beeps every 10 seconds for Line Failure.
|
Battery Low
|
Beeps every 1 second, after 75% of battery discharge till UPS trips Off due to Low Battery.
|
Interface (Optional)
9 Pin, ‘ D’ Connector
|
Provides AC Failure, Battery Low and Shut Down Signal for manual Shut Down. Can support single PC or Server under NOVEL, NetWare, UNIX, MS-DOS, MS-WINDOWS. Special Interface Cords and associated software are available.
|
Physical Dimensions
|
110 x 335 x 185 mm (W x D x H)
|
Weight
|
9.5 Kg (Including Internal Battery)
|
Output Receptacles
|
6 Amps - 3 Nos.
|